Whirlpool MC8991XT - Manual (Page 5)

Using your convection microwave oven
Convection microwave oven controls
There are three parts in the control section:
-The Digital Display/Clock and Indicator Lights.
-Command Pads
- Number Pads
Instructions for each control are covered on the
following pages. Read them carefully.
QUICK COOK COOK PROBE KEEP
DEFROST POWER TEMP WARM
/ o n n
I L U U
PRE- CONV. COMBO AUTO MINUTE
HEAT START TIMER
- MICROWAVE -
Microcomputer
When you first plug in the oven, a tone sounds and
the Display will show 888:88. If after you set the
Clock (page 6), the Display again shows all 8's,
your electricity was off for a while. Reset the
Clock.
Digital display/clock and
idi( indicator lights
I _ i n I I
I L U U
When you are not
using the convection
microwave oven, this is
an accurate digital
clock. When you are
using the oven, it dis­
plays time settings, indi­
cator lights and shows
what number pads you
touched.
Command pads
QUICK
DEFROST
I
ROAST
TIME
-
COMBO
Touch Command Pads
to tell the convection
microwave oven what to
do and in what order.
A few examples:
-CLOCK SET tells the
oven you are going
to set the clock.
- START tells the oven
to start.
See page 6 for informa­
tion on the tone you hear
when touching any pad.
Each Command Pad,
(except START, CANCEL,
PAUSE, AUTO SENSOR,
TEMP RESET and CLOCK
SET) lights an Indicator
Light on the digital
display. The Indicator
Light comes on when
you touch the Com­
mand Pad.
While the oven is running, an Indicator Light (or
lights) will be on to show what the oven is doing.
Number pads
Once you’ve touched
a Command Pad to
tell the oven what you
want it to do, you’ll
touch Number Pads to
tell it...
- a time,
- a Cook Power,
- a food temperature,
- an oven temperature.