Carl Goldberg GBGP0102 - Manual (Page 7)

7
10. Drill six 5/64" [2mm] evenly spaced holes along the line
you made earlier. If you will be clear-coating or staining your
field box, erase or sand off the pencil marks you made. Install
six 10mm sheet metal screws using six small flat washers.
11. Test-fit your power panel and make sure that it fits in
the cutout of the power panel face plate (part #16). If not,
use your rotary tool to enlarge the opening. Be careful not to
remove too much material.
12. Place a long piece of masking tape along the top
edge of the battery cover. This will keep the power panel
cover from being glued to the battery cover. Glue the two
5/16" x 5/16" x 5-1/8" [8x8x130mm] sticks to the battery box
sides so that they are flush with the tops of the sides. Glue
one stick on each side.
13. Apply a bead of glue to the rails and set the face plate
into position. When you’re satisfied with the fit, hold it in
place with a few strips of masking tape. Allow the glue to dry.
14. Remove the battery cover and wick one drop of thin
CA into each of the screw holes in the hardwood rails.
15. Route your power panel’s wires through the hole
you drilled in the battery shield and fit the power panel to
the face plate. Drill four 5/64" [2mm] holes. Use four 10mm
sheet metal screws with four small flat washers to attach
your power panel. Remember to harden the screw holes
with a drop of thin CA.