Carl Goldberg GBGP0102 - Manual (Page 10)

10
9. Turn the drawer over and sand the bottom edge of
the drawer face panel flush with the base of the drawer.
10. Repeat steps 6 through 9 for the other drawer.
11. Check the fit and operation of both drawers. Please
realize that there might still be a bit of a twist in each
drawer which may affect operation, but with weight in the
drawer the drawer should straighten itself out and the gaps
between the panels should line up. Sand the edges of the
drawer faces to create an evenly spaced gap all the way
between each drawer.
12. Depending on how you care to arrange your flight
box, install the upper tray dividers (parts 5&6). Fit your
starter, transmitter, and any other gear in the upper tray and
mark the position of each divider. Use a jigsaw, coping saw,
or your Dremel tool to make cutouts that fit your field gear.
INSTALL THE CRADLES
This section details the installation of the optional adjustable
fuselage cradles. If you want to use these cradles on your field
box, follow the steps detailed in this section. If you don’t want
to use them, skip to section Apply Your Choice of Finish.
1. Install a blind nut in the pre-drilled hole in each of the
uprights from the outside. Tap it in place with a hammer
using a block of wood on the other side of the upright to
help you hold the box in position as you install the blind nut.
2. Wick some thin CA into the end-grain of the plywood
cradle arms (parts 17 & 19). This will make them stronger.
3. Glue cradle spacer 21 onto cradle arm 19. Be careful
to align the edges and the semi-circular cutouts. Make a left