Carl Goldberg GBGP0102 - Manual (Page 6)

6
5. Use a pocket ruler to make a mark 5-3/4" [146mm]
up from the base on the left upright. Make a mark at the
corner of both battery box sides and the upright. Install the
remaining 5/16" x 3/8" x 7" [8x10x187mm] hardwood rail onto
the left side upright so that the top edge of the rail is 5-3/4"
[146mm] from the base, or even with the marks you made.
6. Glue the battery shield (part #12) in place. Clamp or
tape the battery box sides together. Apply a bead of glue to
all joints.
7. Drill a hole in the battery shield to route the power
panel wires through. Start with a 3/8" [9.5mm] drill bit and
enlarge the hole with a Dremel
® tool or equivalent rotary
tool fitted with a sanding drum to enlarge the hole.
8. Fit the battery cover in place so that both sides of the
cover are even with the battery box sides and the beveled
edge sits as shown. Using a pencil, make a mark on the
cover centered approximately over each hardwood rail. Do
this for the left and the right side of the cover. Draw a faint
line parallel with the edge of the cover all the way down to
the bottom along the marks you made.
9. Tape the battery cover (part #29) in place so that the
beveled edge of the cover is flush with the angled edge of
the battery box sides. The battery cover is properly aligned
if the power panel face plate sits flat against the beveled
edge and the battery box sides.