Carl Goldberg GBGP0102 User Manual
Page 15

15
14. Drill one 5/64" [2mm] hole on each side of the hook
and loop strap. Install the strap using two 10mm sheet
metal screws and two small flat washers.
15. Trim the ends of the strap. Note: Extra hook and loop
material, screws, and washers are supplied if you want to
use a second strap.
16. If you want, you can use a scrap piece of hook and
loop material to hold your fueling line.
17. After you’re done with your field box, you can add
feet (not included). Circular rubber, nylon, or felt bumpers
are available at your local hardware store.
18. As an added option you can use four #6 x 3/4"
[19.1mm] sheet metal screws and washers (not supplied) to
reinforce the uprights. Draw lines across the base centered
with each upright. Drill four 7/64" [2.8mm] holes into the
uprights and install the screws and washers.
19. Your field box is now ready to be outfitted with all of
your tools and flight line equipment. Some items you may
want to carry are listed in the section titled: Field Equipment
Suggestions, at the start of this manual.