Carl Goldberg GPMA1926 Monster Pitts Electric ARF User Manual
Page 17
17
3.
With the hatch mounted on the fuselage,apply
a small bead of canopy glue to the inside edge
of the canopy and tape in place on the hatch.
Be careful around the turtle deck to make sure
you don’t glue the hatch to the fuselage.
Receiver-Battery Installation
1.
The receiver can go just in front of the ser-
vos, the battery will fit just forward of the
receiver and the speed control can go in
the nose compartment.
Important: The battery must have some
sort of retainer over the top, Don’t depend
on the canopy to hold it in place.
Important:
Don’t glue the canopy to the hatch without
the hatch being installed on plane. If you
glue it off the plane it might not fit when
you try to install it.
battery
servos
CG and Control Throws
The CG should be 1” behind the leading edge of
the bottom wing. Our model balanced and flew
with no added weight set up as shown.
Notice:
The plane is very responsive with a
high rate of roll, so be ready for snap-
py performance. Do not fly on high
rates on your first flight.
Elevator Low Rate 3/4” each way
High Rate All you can get
Ailerons Low Rate 3/8” each way
High Rate All you can get
Rudder Low Rate 1” each way
High Rate All you can get