Carl Goldberg GPMA1926 Monster Pitts Electric ARF - Manual (Page 16)

16
7. Slide the cowl in place over the front of the
fuselage. It should overlap the front of the fuselage
about 1/4”.
8. Make sure the paper strips are on the outside
of the cowl.
9. Align the stripes on the cowl with the stripes on
the fuselage. Make sure cowl in straight with
the top of the fuselage, not angled up or down.
Check alignment left and right by looking
down on the fuselage from the top. Use mask-
ing tape to hold the cowl in place.
10. When satisfied with the alignment, drill a 1/16”
hole at the mark on the paper strip into the
mounting block.
11. Remove the cowl and open the holes in the
cowl with a 5/64” drill. Re-install the cowl and
mount with three #2 x 3/8” screws.
Canopy and Hatch
1. Collect the following items:
fuselage
hatch
canopy
(2) #2 x 3/8” screws
screw hole
2. The hatch is held in place with two dowels on
the front that fit into the bulkhead and two
screws into the mounting holes on the side of
the fuselage.