Carl Goldberg GBGA1041 - Manual (Page 12)

12
Wheel Collars
Wheel Pant
Wheel
Landing Gear
7. Mount the wheel pants back on the landing
gear along with the wheel collars and wheels.
8. Center the wheel on the axle.
ENGINE INSTALLATION
1. Collect the following items:
(2) Motor Mounts
(1) Engine
(8) 8-32 x 1-1/4” phillips Head Screw
(4) 8-32 Locking Nut
(8) #8 Washer
(4) 8-32 Blind Nut
2.
Place you engine in the mounts and adjust till
the prop drive washer is 5-7/8” from the fire-
wall. Clamp the engine in place and and mark
the location of the mounting holes. Drill using
a 11/64” bit.
Screw the engine onto the motor mount using
the 8-32 x 1-1/4”” screws and locking nuts.
3.
Keeping the engine perpendicular to the table
top, clamp the other motor mount to the
engine. Mark and drill the second motor mount
then screw the mount to the engine.
4.
Place the motor mount onto the firewall.
Center the motor over the horizontal and ver-
tical lines.
5.
Install the motor mount beams on to the fire-
wall plate using the 8-32 x 1-1/4” phillips Head
screws and washers and 8-32 blind nuts
USE THREAD LOCK ON ALL SCREWS