1005nc eng 4 5, Programming user settings, Temperature adjustment – Braeburn 1005NC User Manual

Page 3: Additional operation features, Battery replacement, Troubleshooting

Review Set Temperature

1. Press and hold button. The current set point temperature will be displayed in the

place of the current room temperature, and the indicator

SET will be displayed.

2. The display will return to normal operating mode when the button is released.

The

SET indicator will turn off indicating that the current temperature shown in the

display is the room temperature. Continuing to hold the button for 3 seconds or

longer will allow the user to change the current set point temperature.

NOTE:

The installer can reset the thermostat and bypass the compressor protection feature by pressing the RESET

button. This will erase all user program settings and should only be used during installation for testing purposes or to

reset a thermostat to regain normal operation. This will return all thermostat settings to their default values.

Changing Set Temperature

Compressor Protection Feature

1. Press and hold button at the same time for 3 seconds. The entire display

will flash once and the

SET indicator will be flashing. Release the button

and press the button again as desired to adjust the set temperature.

2. The display will return to normal operating mode after 5 seconds.

3. The SET indicator will turn off in the display indicating that the current temperature

shown in the display is the room temperature.

NOTE:

Once you have finished setting the temperature differential, you can wait 5 seconds and the thermostat will

automatically return to the normal operating mode.

NOTE:

To erase all user program settings, gently press RESET button using a paperclip or a small pencil tip.

This will return all thermostat settings to their default values.

cont.

This thermostat includes an automatic compressor protection feature to avoid potential damage to the cooling system from

short cycling. This thermostat automatically provides a 5-minute delay after turning off the cooling system output to protect

the compressor.

Programming User Settings

Temperature Adjustment

Additional Operation Features

Resetting Thermostat

Low Battery Detection and Replacement

Replacing the Batteries

1. Open the battery compartment door.

2. Gently remove the two "AA" alkaline batteries located in the battery compartment.

3. Install two new "AA" alkaline batteries into battery compartment. Make sure to match the positive (+) ends of the

batteries with the positive (+) terminals located in the battery compartment.

4. Close battery compartment and verify that the low battery indicator does not appear in the display.

The Reset feature allows the user to completely reset the thermostat to register new manual switch settings and return to

factory set software settings. To erase all entered settings, gently press

RESET button using a paper clip or a small pencil tip.

cont.

Thermostat does not

turn on system.

Check to see if

OFF is shown in display. This indicates that the

system is turned off at the thermostat. Move the system selector

switch to the

ON position.

Compressor protection features may be in effect due to

compressor short cycle conditions. See Compressor Protection

Feature, section 6 for a full explanation of this feature.
System may be malfunctioning. Call a professional service

technician immediately to verify system operation.

SYMPTOM

POTENTIAL SOLUTION

This thermostat requires two (2) properly installed "AA" alkaline batteries to provide power for the thermostat to properly

control the system operation.
This thermostat is equipped with a low battery detection feature that constantly monitors

the batteries during normal operating mode to determine whether they have sufficient

power to provide proper operation.
When this feature determines that the battery status is low, a low battery indicator will appear

in the display. It is recommended that the batteries be replaced immediately to maintain

system operation and program settings.

Additional Operation Features

Battery Replacement

COOL

Status Indicators

HEAT: The word “HEAT” will appear in the display when the

heating system is running.

COOL: The word “COOL” will appear in the display when the

cooling system is running.

Troubleshooting