Braeburn 7320 User Manual - Manual (Page 29)

5 Additional Operation Features
Auto Changeover Mode
Auto Changeover mode is a feature enabled/disabled in the
Installer Settings (see Installer Guide). If enabled, it is selected
by touching the SYSTEM TouchPad until AUTO HEAT or AUTO
COOL appears below the TouchPad.
When Auto Changeover mode is enabled and selected, the system
automatically switches between heating and cooling when the
room temperature meets the programmed heating or cooling set
points. To operate properly, the thermostat requires a “dead band”
setting to eliminate program conflicts. The dead band is set in the
Installer Settings (See Installer Guide). The default setting is 3° F.
Therefore, you will not be able to set your heat or cool temperature
within 3° F of each other. If a setting is made in either heating or cooling which violates the dead band, the
opposite mode will adjust up or down automatically to maintain the programmed dead band spacing.
HUMID
29 User Manual