Awntech DESTIN - Manual (Page 23)

23
RIGHT MOTOR MOUNT (when you face the house):
If the awning stops from closing completely:
1. Identify the White Limit Control (Away from the wall)
2. If the awning stops from retracting completely, then turn the Limit Control “CLOCK WISE” direction (one
turn at a time) until it retracts completely.
If the motor continues to turn even after the awning completely retracted then do the following:
1. Identify the White Limit Control (Away from the wall)
2. Stop by pressing the stop button
3. Extend the awning about two feet and then
4. Then turn the control “COUNTER CLOCK WISE” (three full turns) and then push the button to retract. If
the awning still continues to retract more then repeat the steps until it is completely adjusted.
If the awning doesn’t extend fully or to your desired extension then do the following:
1. Identify the Red Limit Control (Close to the wall)
2. If the awning doesn’t extend fully or to your desired extension, then turn the Red Limit Control “CLOCK
WISE” until it opens completely or it reaches till your desired extension
If the awning continues to extend beyond your desired extension, then do the following:
1. Stop by pressing “Stop” button
2. Retract the awning by pressing “Retract” button for about two to three complete turns and press “Stop”
to stop it from further retracting
3. Turn the Red Limit Control “COUNTER CLOCK WISE”
4. Press to extend, if it extends still too much then
5. Repeat the above steps until it reaches your desired extension.
You can always use extend and retract manually by pressing the controls on your remote control.
HOOD ASSEMBLY INSTRUCTIONS FOR DESTIN MODEL RETRACTABLE
AWNING
Parts List
Name Awning Size Qty
Hood All 1
S-Brackets 8 1
S-Brackets 10, 12 2
S-Brackets 16, 18, 20 3
S-Brackets 24 6
End Caps All 2
Hardware as needed