Awntech DESTIN - Manual (Page 21)

21
• If the LED light is red on the remote control and the motor doesn’t function:
• Please check the power supplies to the motor
• Check cable connections
• The motor has an internal temperature control and shuts off the motor for twenty minutes
until the motor cools off. So…wait for twenty minutes and then try to operate it.
In case of an emergency or if you have questions,
contact our technical support team at 800-200-5997 M-F (9-5 CST).
PROGRAMMING THE REMOTE CONTROL
The programming button (P2) is located in the battery compartment. Please open
the battery compartment and locate the small rectangular shaped push button.
• To program the Remote Control (transmitter) - Always unplug the motor first .
Power up the motor and then within 6 seconds push the “program” button two times and
push the “ up” button once
If you want to reset the entire program then follow steps (2) and (3)
• To delete the program of an old Remote Control (transmitter ) - Always unplug the
motor first. Power up the motor, press the “ program” button once, then within 6 seconds
press and hold the “stop” button for two seconds then release
• To re-program or reset the Remote Control (transmitter ) – Always unplug the motor
first. Power up the motor and then within 6 seconds push the “program” button two times
and push the “ up” button once
• To change the direction - Always unplug the motor first
Power up the motor, press the “ program” button once, then within 6 seconds press the
“up” button once, if the direction not reversed then unplug the motor again and then Power
up the motor, press the “
program” button once, then within 6 seconds press the “down”
button once.
• Add an additional Remote Control (transmitter) - Always unplug the motor first
Power up the motor, press the “ program” button two times on the existing remote,
within 6 seconds press the “program” button once on the additional Remote Control
(transmitter) and then press “UP” button once on the additional transmitter.
CAUTION: IMPROPER ADJUSTMENTS CAN CASUE THE AWNING MOTOR TO BREAK.
MOTOR Model:
AT45MR
Limit Adjustment Control Operation
VERY IMPORTANT:
YOU MUST ADJUST THE CONTROLS FROM THE BOTTOM OF THE MOTOR
The motor has internal temperature cutoff switch. If the motor gets too hot it will stop working, it
will start working after 20 minutes or as soon as motor cools down. Do not worry, this motor has
manual override option and you can always open or close the awning manually by using the crank
handle.
This motor has a limit control switch to control the extension and retraction of your unit. The limit
adjustments controls are in Red and White are located next to the electrical cord of the motor. In