Mobile base assembly parts – American Diagnostic Corporation (ADC) e-sphyg2 9002 User Manual
Page 5

24
5
Warnings and Precautions
Warning - A warning statement in this manual identifies a condition or practice which, if not
corrected or discontinued immediately could lead to patient injury, illness, or death.
Warning - If luer lock connectors are used in the construction of tubing, there is a possibility
that they might be inadvertently connected to intravascular fluid systems, allowing air to be
pumped into a blood vessel. Immediately consult a physician if this occurs.
Warning - Do not allow a blood pressure cuff to remain on patient for more than 10 minutes
when inflated above 10mmHg. This may cause patient distress, disturb blood circulation, and
contribute to injury of peripheral nerves.
Warning - Safety and effectiveness with neonate cuff sizes 1 through 5 is not established.
Warning - For all blood pressure systems that can be wall mounted, ensure that the unit is
securely mounted prior to use to avoid damage to the instrument and potential patient injury.
Warning - Do not use the 9002 in an explosive environment such as where flammable anesthet-
ics exist or inside an oxygen chamber with strong electrostatic and electromagnetic fields e.g.,
mobile phones.
Warning - Use of this instrument on patients under dialysis therapy or on anticoagulant,
antiplatelets, or steroids could cause internal bleeding.
Warning - Do not use cuffs, AC adapters or batteries other than those included with this product
or replacement parts supplied by the manufacturer.
Warning - This system may fail to yield specified measurement accuracy if operated or stored in
temperature or humidity conditions outside the limits stated in the specifications section of this
manual.
Caution - Federal law restricts this device to sale by or on the order of a physician or licensed
healthcare practitioner.
Caution - To avoid any possibility of accidental strangulation, keep this unit away from children
and do not drape tubing around your neck.
Note - To obtain the greatest accuracy from your blood pressure instrument, it is recommended
that the instrument be used within a temperature range of 50°F (10°C) to 104°F (40°C), with a
relative humidity range of 15-90% (non-condensing).
Note - All connectors and inflation system should remain connected to the device during storage
to avoid dust entering through the connector port.
ADC Item
Item no.
1
Center Pole Screw (1) Washer (1) 972-101
2
Base
972-080
3
Casters (5)
972-106
3A Single Caster
972-106-1
4
Outer Pole
972-107
5
Knob
972-108
Mobile Base Assembly Parts
ADC Item
Item no.
6
Spring
972-109
6A Gasket, Rubber
972-107A
7
Inner Pole
972-110
8
Basket Tightening Key
972-111
9
Basket
972-112
9B Manometer Mounting Hardware 752-114
9B
4
5
6
7
8
9
6A
1
2
3
3A