ALTANA LC 3 - Manual (Page 8)

Determining/Setting the cell constants BYK LC 3
8
Procedure for manually setting the cell constant:
Procedure for selecting fixed cell constants 0.010 cm
-1
:
! Press . The AutoRead measurement begins.
! If the measured value is stable, the instrument displays the determined
cell constants and the calibration evaluation. The measuring instrument
automatically stores the cell constants.
! Switch to the measuring mode with . 3 0 7 4
Cal
cm 1/
Tref25
A L C
! Press the key repeatedly until the CELL display appears.
! Then press the key.
! Press the key until a measured value and a value for the cell con-
stant appears in the required setting range.
! Set the value of the cell constant with < ▲> <▼>.
! Switch to the measuring mode with .
L C L E
4 0 1 6
8 0 6
cm 1/
S/ cm
Tref25
nLF ARng
! Press the key repeatedly until the CELL display appears.
! Then press the key.
! Press the key until a measured value and the cell constant
0.010 cm
-1
appear.
! Switch to the measuring mode with .
L C L E
0 0 1 0
2 5 9
cm 1/
S/ cm
Tref25
nLF ARng