ALTANA LC 3 - Manual (Page 10)

Configuring BYK LC 3
10
Configuring
Note
You can leave the configuration menu at any time with . The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
! Switch off the measuring instrument.
! While pressing the key, press <
>.
! Select the required Baud rate with < ▲> <▼>.
Selection: 1200, 2400, 4800, 9600 Baud.
! Then press the key.
! Set the required calibration interval with <
▲> <▼>.
Selection: 1... 180... 999 d.
! Then press the key.
! Switch the automatic measuring range selection AutoRange on/off with
<
▲> <▼>.
Selection: YES (On), no (Off).
! Then press the key.
! Switchover the reference temperature of the conductivity with < ▲> <▼>.
Selection: 25 °C (Tref25) and 20 °C (Tref20).
! Then press the key.
! Switch the units of the conductivity display on/off with < ▲> <▼>.
Selection: S/cm, M
Ω ⋅
cm.
! Then press the key.
! Select the date and time step-by-step with < ▲> <▼>. In between, press
the key each time.
! When the last key has been pressed, the instrument
changes to the last active measuring mode.
Baud 0 4 0 8
Time 0 d
T 3 n 1
8 1
S E Y
ARng
n r A
Tref25
2 5 t
d n o C
cm S/
Day.Month
4 0 0 9