ALTANA LC 3 - Manual (Page 11)

BYK LC 3 Resetting to default settings
11
Resetting to default settings
You can reset the measurement parameters and the configuration to the de-
livery status separately from one another (initialization).
Measurement
parameters
The following measurement parameters can be reset to the delivery status:
Configuration
parameters
The following configuration parameters (InI) can be reset to the delivery sta-
tus:
Reset procedure:
Conductivity ( InI)
Measuring mode
AutoRange, automatic switchover
of the measurement range On (YES)
Cell constant 0.475 cm
-1
(calibrated)
0.475 cm
-1
(manual range I)
0.100 cm
-1
(manual range II)
Temperature compensation nLF
Temperature coefficient of the lin-
ear temperature compensation 2.000 %/K
TDS factor 1.00
Baud rate 4800
Interval 1
(automatically saved)
OFF
Interval 2
(for data transmission)
OFF
! To switch it off, press <t> while pressing the key.
! To reset the measurement parameters with <
▲> <▼>, select YES and
confirm with , or
! Continue to the configuration parameters (InI) without resetting with the
key.
! After the configuration parameters, InI changes the instrument to the last
active measurement mode.
o n
I n I