ALTANA Gardner-Scrub Manual User Manual
Page 4

2
Preparations
Unpack the unit being careful to check all packaging for items. Some accessories required for
specific tests may be found in a separate box within the main box.
Within the package are the following standard items:
Quantity
Description
1
Gardner-scrub main unit
1
Power Supply
1
Power Cord
1
Drip Pan
2
Sample Clamp springs
Find a suitable location free from obstructions and clutter. The Gardner-scrub should be at a
convenient height for the operator.
Plug the power supply into the DC input jack on the left side, next to the power switch. A
power cord appropriate for your area’s power connector is supplied to connect the power
supply with AC power. The system will operate on power from 100-240 V~ at 50-60 Hz.
Using the bubble level on the top of the cover, adjust the 4 feet on the bottom of the unit to
level the instrument to the work surface.
Place the drip pan in the provided indentation on top of the unit.
There are two sample clamp springs provided with the unit. Screw the knobs into the shafts
located at the back corners of the unit until you can lift the shaft to its full extension. Then
tighten the knob fully.
Push the knob into the spring Screw the knob into the shaft