A&D Weighing FX-300i-PT - Manual (Page 8)

6
Stand
Angle
adjustment
knob
Weighing
unit
Display
Connection
cable
Sample cup
holder (5 mL)
5 mL sample
cup 30 mL sample
cup
Sample cup
holder (30 mL)
2. ASSEMBLING THE TESTER
2-1 AD-4212B-PT / AD-4212A-PT
1. Place the weighing unit on a solid table. For details
on the installation site, refer to “3. PRECAUTIONS
BEFORE USE”.
Secure the display to the stand using the angle
adjustment knobs. Connect the display and the
weighing unit using the connection cable.
2. Install the evaporation trap base on the weighing
unit.
3. Install the sample cup holder (30 mL) on the base.
When the 30 mL sample cup is used:
Insert the sample cup into the holder.
When the 5 mL sample cup is used:
Insert the sample cup holder (5 mL) into
the sample cup holder (30 mL), and then
insert the sample cup
Evaporation
trap
base