A&D Weighing FX-300i-PT - Manual (Page 4)

2
1. INTRODUCTION
The PT series Pipette Accuracy Tester performs an accuracy test of the volume of a pipette in
accordance with ISO 8655.
This manual describes how the PT series Pipette Accuracy Tester works and how to get the most out
of it in terms of performance. It includes how to assemble the tester, how to measure and how to use
the software, WinCT-Pipette, for pipette accuracy testing.
Read this manual thoroughly before using the tester and keep it at hand for future reference.
For detailed information on handling the balance, refer to the instruction manual for the balance used.
NOTE ISO 8655 is the international standard that includes pipette calibration and specifies a test
method for accuracy of the pipette volume. For detailed information, visit our web site.
1-1 Unpacking the Tester
NOTE The pipette accuracy tester is contained in a carrying case. The case is only for
carrying the tester and is not solid enough to endure transportation. So, do not
transport the tester using the carrying case. When transporting the tester, be sure to
use the original packing material.
When handling the tester, be careful not to drop it, even if it is placed in the carrying case.
The illustrations on the next page show what the PT series consists of.
Note that the USB converter is shipped in a separate package, but it can be placed in the carrying
case as shown below.
A shoulder belt and a key are provided with the carrying case. Use the shoulder belt to carry the
case.
NOTE Please confirm that the AC adapter type is correct for your local voltage and power
receptacle type.