A&D Weighing FX-300i-PT - Manual (Page 20)

18
Displaying modes
The thermometer has three display modes.
Displaying mode Display example
• Current temperature mode
Displays the current temperature.
Maximum temperature • Max/Min temperature mode
Displays the latest maximum and
minimum temperatures that are
automatically stored in the thermometer.
Minimum temperature
• Auto power-off mode
Turns the power off automatically after six
or seven minutes of no operation.
Measuring the temperature
Follow the procedure below to measure the water temperature.
1. Remove the sheath protector from the
thermometer.
2. Press the ON/FAST button to turn the display on.
3. Insert the sensor sheath into the water.
4. The sampling interval is 10 seconds.
To speed this process, press and hold the
ON/FAST button for a sampling interval of every
2 seconds.
5. As the thermometer responds to the water
temperature, the displayed temperature changes,
stabilizes and then displays the water
temperature.
NOTE The thermometer detects the
temperature at the tip of the sensor
sheath. Do not expose parts of the
thermometer other than the sensor
sheath to the high or low temperature
of the test liquid.
MAX / MIN
ON / FAST AUTO-OFF
Water
MA
X / M IN
O N / F AST
AU
TO
-O FF
Temperature
detection
part
Sensor sheath