A&D Weighing FX-300i-PT - Manual (Page 11)

9
4. Install the lower part of the evaporation trap on the
weighing unit, mating the tabs with the holes on the
base.
5. Attach the upper part of the evaporation trap to the
lower part, mating the tab with the notch.
6. Adjust the direction of the evaporation trap so that the pipette insertion opening on the sloped
surface is faced to allow an easy operation.
7. Install cap A on the evaporation trap.
Remove cap B from the sloped surface.
Lower part of
the evaporation trap
Upper part of
the evaporation trap
Cap A
Cap B
Upper part of
the evaporation trap
Lower part of
the evaporation trap
右 左
Pipette
insertion
opening
Pipette
insertion
opening
Facing to the right
of the balance Facing to the left
of the balance
Tab
Hole
Tab
Notch