A&D Weighing SV-100 - Manual (Page 9)

7
2-2 Installing the Viscometer
Install the viscometer as follows:
1 Connect the display unit to the main unit using
the connection cable.
2 Insert the AC adapter plug into the AC adapter
jack located on the rear side of the display unit.
Insert the other end of the AC adapter plug into
an electrical outlet.
Note:
• Confirm that the adapter type is correct for
the local voltage and power receptacle type.
• The main unit and the display unit have been
adjusted in pairs. For accurate viscosity
measurement, before use, confirm that the
main unit and the display unit have the same
serial number.