A&D Weighing SV-100 - Manual (Page 22)

20
5-3 Changing Units
The units of viscosity available are: mPa ⋅s (millipascal second),
Pa ⋅s (Pascal second),
cP (Centipoise),
P (Poise).
The correlation of the units are as follows: 1 mPa ⋅s = 0.001 Pa⋅s = 1 cP =0.01 P
The units of temperature available are: °C (Celsius) and °F (Fahrenheit).
The unit selected upon power-on depends on the function setting. The unit selected at the factory
before shipment is as shown below.
Model Viscosity Temperature
SV-10 mPa･s
SV-100 Pa･s
°C
Use the MODE key to change units. Each time the MODE key is pressed, units are switched as below:
Note that the unit of temperature is fixed in the function setting.
SV-10
In the function setting, mPa ⋅s or Pa⋅s is selected:
In the function setting, cP or P is selected:
SV-100
Note
While the measurement is being performed using the graphing program RsVisco, unit
changes using the MODE key is not available.
With the function setting "fnc 1", pressing the MODE key during measurement will display
the measurement elapsed time.