A&D Weighing SV-100 - Manual (Page 37)

35
Decimal Point (pnt)
Parameter Settings Description
0 • Dot " . "
1 Comma " , "
The decimal point format for the displayed measurement data and the
decimal point code for measurement data output via RS-232C are
specified.
With "Comma" selected, the separator for CSV format and RsVisco
format will be "
; " (semicolon).
MODE Key Function During Measurement (fnc)
Parameter Settings Description
0 •
Switches the viscosity
units.
Each time the MODE key is pressed, the viscosity unit is
switched.
SV-10: mPa ⋅s ⇔ Pa⋅s, cP ⇔ P
sv-100: Pa ⋅s ⇔ P
Note
With the SV-10, for the viscosity over 1000 mPa
⋅s, the
unit is fixed to Pa ⋅s and for the viscosity over 1000 cP,
the unit is fixed to P.
1
Switches between the
temperature display
and the measurement
elapsed time display
Each time the MODE key is pressed, the display is switched
between the temperature display and the measurement
elapsed time display.
Upon a measurement start, the temperature display is
selected.
When the elapsed time reaches 100 hours, the display
returns to 0. (99.59.59
→00.00.00)
Data Output Mode (prt)
The condition to output the measurement data via RS-232C is set.
Parameter Settings Description
0 • Key mode
During measurement or in the data hold mode, pressing the
PRINT key outputs the current measurement values. *2
1 Auto print mode
The measurement values are output automatically when the
STOP key ends the measurement.
Pressing the PRINT key outputs the current measurement
values. *2
2 Stream mode
The measurement values are output continuously during
measurement.
When D.P. format is selected in "Output format (type)" of the
function setting, only the viscosity value is output, regardless
of the settings of "5-at", "5-td" and "5-ed".
When this mode is selected, the data hold mode using the
HOLD key is not available.
*2 When A&D standard format is selected in "Output format (type)" of the function setting,
pressing the PRINT key in the standby mode will not output the measurement data.