Hangar 9 Piper J-3 Cub 40 ARF - Manual (Page 24)

24
 Step 4
Repeat Steps 2 and 3 for the remaining elevator
control horn.
 Step 5
Attach the elevator pushrod to the servo arm of the
elevator servo using a pushrod wire keeper.
 Step 6
Bend each of the fittings (small and large) to about a
45-degree angle.
 Step 7
Attach the large brass fittings at the bottom rear of the
fuselage using the #2 x 1/2" sheet metal screw.
 Step 8
Attach the small brass fitting to the fin and stabilizer
using 2-56 x 1/2" screws, #2 washers and 2-56 nuts.
Fittings are placed on both sides of the rudder and
the top and bottom of the stabilizer.
 Step 9
Slide a clevis retainer onto a clevis. Thread a cable end
into the clevis. Prepare four of these connectors.
Section 7: Installing the Stabilizer