Doepfer A-190-1 MIDI-CV/Gate/Sync Interface - Manual (Page 18)

A-190 MIDI-CV/SYNC interface System A - 100 doepfer
18
4.5 PERFORMANCE mode
In performance mode the A-190 converts incoming
MIDI messages into CV and gate signals. As well as
those already mentioned in chapter 4.4, it also re-
cognises and converts the following controller messa-
ges. (H "ch" is short for ‘MIDI channel’).
CONTROLLER #01 (Modulation)
This controller affects modulation intensity - ie. the
amount of LFO voltage included in CV1.
M M M M
CONTROL ch 01 n
n : 0 to 127
CONTROLLER #05 (Portamento Time)
This controller affects portamento time (see PER-
FORMANCE menu 3). Changes made using this con-
troller are only temporary: they are not stored during
the ‘save’ procedure, and on power-up, the A-100 will
revert to the default factory setting.
M M M M
CONTROL ch 05 n
n : 0 to 127 Portamento time
CONTROLLER #64 (Sustain)
This controller switches sustain on and off.
M M M M CONTROL ch 64 n
n : 0 to 63 Sustain Off
64 to 127 Sustain On
CONTROLLER #65 (Portamento)
This controller switches portamento on and off.
M M M M CONTROL ch 65 n
n : 0 ... 63 Glide Off
64 ... 127 Glide On