Doepfer A-190-1 MIDI-CV/Gate/Sync Interface - Manual (Page 14)

A-190 MIDI-CV/SYNC interface System A - 100 doepfer
14
4.3 PERFORMANCE Menus
CHANNEL
The CHANNEL parameter sets the MIDI receive
channel. MIDI messages received on this channel in
performance mode are converted into CV and gate
signals and output to whatever modules are connected
to the A-190.
[m m m m
Set the MIDI channel (1 to 16) ]
H It’s better to set MIDI channel by a MIDI
message in config menu 1, where control is
more direct.
LFO FREQ.
The LFO Freq. parameter controls the frequency of the
A-190’s built-in LFO.
Use your ears to decide the correct frequency. With a
parameter value of less than 3, the LFO is switched
off.
m m m m Set the LFO frequency
(from about 0.2 Hz to 20 Hz)
H The INC- / DEC- buttons will speed up
if you keep them pressed down.
H With the A-190, you’re effectively getting an
extra software LFO, controlled over MIDI,
which can supplement the ‘real’ LFOs (A-
145, A-146) in your A-100 system.
Performance Menu 1
Channel
2
Performance Menu 2
LFO Frq.
2