COP-USA DVR2704XE-L - Manual (Page 33)

DVR User Manual
27
Step 2: Select the Schedule tab. This will bring up the schedule setup interface.
The setup steps for schedule for alarm out are similar to normal schedule setup;
you can refer to 4.4.1 Schedule for details.
This step is very important for alarm out. Even if you have enabled alarm out in
the motion based alarm or sensor based alarm, you will not see the result of
alarm out if no schedule is added here.
Buzzer
It is an inbuilt alarm output device. To setup Buzzer: Fig 4-25 Alarm Out
Step1: Enter into MenuSetupAlarm out Buzzer tab;
Step2: Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzer when the system is in alarm.
4.6 Network Configuration
Network configuration includes five submenus: network, sub stream, Email, server
and other settings. Network settings must be configured if DVR is used for
monitoring over network.
4.6.1 Network
Step 1: Enter into MenuSetupNetworknetwork tab. Refer to Fig4-26:
Step 2: HTTP port: the default value is 80. If the value changed, you need to modify
the IP address in the IE address .i.e. if HTTP port is 82 and IP address is,
192.168.0.25 , you shall input http://192.168.0.25:82 in IE browser.
Server port: Communication port.
Step 3: Connect internet. If you have a DHCP server running and would like your
DVR to automatically obtain an IP address and other network settings from that
server, check the checkbox beside "Obtain an IP address automatically". Then the Fig 4-26 Network Configuration-Network