Checkline MTM - Manual (Page 13)

AWS-MTM-DP Guide
PROGRAMMING 12
F ULL S CALE
This screen shows the Full Scale value of the Torque Shaft. This is not a field adjustable
value.
L OW L IMIT
Use the low limit setting as a means of visually flagging the operator when a reading fails
to reach a desired minimum value. A small down arrow will appear on the screen is a
peak is captured below the limit setting.
The limit is adjusted by using the navigation buttons to set the first four digits to the
desired value. The fifth digit is used to select the decimal point position. The up and
down buttons under the “Soft” button Change will change the value from 0-9. Pressing
the “soft” DIG will scroll through the digit positions. When the correct value is entered,
pressing the ENT button will return you to the menu system.
Once all the digits have been set, press the
M EM
key to accept the value and return to
Program Function mode. The next time a reading is taken, "LO" will appear on the
display if the captured value is less than the low limit
H IGH L IMIT
Use the high limit setting as a means of visually flagging the operator when a reading
falls over a desired maximum value.
High limits are set in the identical way as low limits. Please refer to the Low Limit section
for details.
NOTE ON LIMITS: The green LED on the front of the display will flash when a peak is
captured that falls within the limit setting.
S
LEEP
M
ODE
To conserve battery life, the MTMDP is equipped with a "sleep" mode, which sets the unit
to standby after a user-settable amount of time has passed without activity.
Press the + key to increase the number of minutes the unit will wait for input, or press
the - key to decrease the number. This example shows a value of four minutes.
The highest possible sleep setting is 20 minutes. Press
EN T
to accept the value and
continue to the next function.