Checkline ZP - Manual (Page 5)

page 5 page 16
Programming Setpoints (optional)
Program High and Low setpoints for easy GO/NO GO testing.
1. Turn on the gauge
2. Press and for 3 seconds to enter Power-On program-
ming mode (CF9 flashes with solid F0).
3. Press to display flashing CF9 with solid F1,
then press to display –HI– and then the
high set value (i.e. H 10.0).
4. Press to increase and to decrease the
High set value, then press to display –LO–
and then low set value (i.e. L 5.0). Press to
increase and to decrease the Low set value and press
to display flashing CF9 with solid End.
5. Press again to exit Power-On programming mode.
Hand Tighten (No tools!) the selected attachment to the measur-
ing shaft.
HIGH SETPOINT
LOW SETPOINT
Reversing the Display
The factory default is standard display.
To reverse the display:
1. Turn on the gauge
2. Press and for 3 seconds to enter
Power-On programming mode (CF9 flashes
with solid F0).
3. Press 5 times to display flashing CF9 with solid F5, then
press to display -12345. Press or , to cycle between
standard and reverse .
4. Press to select, the display flashes CF9 with solid End.
5 Press again to exit Power-On programming mode.
Once desired display is selected, the gauge retains it as a default.
-1 23 45
DIGITAL FORCE GAUGE
00.0
NG
Lb
OK +NG
OVERLOAD
ZERO
SEND PEAK
ON OFF
DIGIT AL FORCE GA UGE
00.0
NG
Lb
OK +NG
OVERLO AD
ZERO
SEND PEAK
ON OFF
STANDARD
DISPLAY
REVERSE
DISPLAY
2. Connect the ZP, ZPH or ZPS
force gauge to computer with
the USB cable provided.
Welcome to the Found New
Hardware Wizard should appear.
3. Insert the Driver CD-ROM
(included with force gauge)
and select “install software
automatically.” Click Next and
follow onscreen instructions. When prompted to search the
Web select “No not this time” and click Next.
4. If a Windows XP compatibility message appears, select “con-
tinue anyway.”
5. After the ZP driver is installed select “Finish.”
Install USB driver
1. Turn on the gauge and confirm the USB
caption is visible on the gauge display
(If you have already installed the USB
Driver for ZP Recorder you do not have to do it again).
If the caption is not present turn off the gauge.
Press again while holding
, CF9 flashes with solid m0.
Press or to cycle CF9m0, CF9m1, CF9m2, CF9m3 and
CF9End. When CF9 m3 appears press to select.
Then press or to cycle. ‘USb’: USb output or ‘232C’:
RS232 output. Press to select ‘USb’, CF9End displays,
press to exit.
ZP Logger
ZP Logger is a USB software utility that can download and log all
data stored in gauge memory and log all force values sent to gauge
memory while the gauge is online. ZP logger saves data files in
CSV format.