Zp logger operation, Page 3 page 18 – Checkline ZP User Manual

Page 3

page 3

page 18

Programmable Setpoint LED’s
When high-low setpoints are set,
LED indicates below (-NG), within
(OK), or above set point value
(+NG).

Compression icon
Indicates compression measurement.

Tension icon
Indicates tension measurement.

Reverse +/– values

Auto Zero Reset icon
Programmable auto zero reset
duration

Auto Memory - Peak Reset icon

USB output icon

Battery icon
Flashes when Ni-MH cells need
charging.

PEAK icon
Displays continuously when peak
function is active.

HOLD icon
Displays when external hold signal
is active or SEND button is pressed.

Alarm Icon

Auto Power Off icon

Units icon
Displays selected measuring units.
(ozf, Lbf, gf, kgf, or N)

Overload Indicator
Flashes at 110% of rated capacity.

AC ADAPTER/CHARGER
RECEPTACLE

MEASURING SHAFT

WARRANTY
SEAL

NON-SLIP RUBBER GRIP

COMMUNICATION PORT
USB, RS-232 &
±2VDC ANALOG

ZP, ZPH, and ZPS (with remote sensor) use the same keypad.

Download Gauge Memory –

On startup of ZP Logger press
the Read Memorized button to
download and log gauge memo-
ry to ZP Logger. This feature is
disabled if Read Current Val but-
ton or the Send key on gauge are
pressed or enabled if the Clear
key is pressed. Data can then be
saved by using the File menu or
Save button.

Record Gauge Data –

Press the Send key on the gauge
or the Read Current Val button
on the ZP Logger. Peak or real
time data goes into internal
gauge memory as well as ZP Logger.

ZP Logger Operation

1. Click Start/Programs/Imada/ZP Logger
2. Turn on the gauge and confirm the USB

caption is visible on the gauge display.

3. Connect the ZP, ZPH or ZPS force gauge

to the computer with the USB cable provided.

4. Turn on the gauge. The ZP Logger Online/Offline indicator

should change to Online (blue).

If Indicator doesn’t change to Online, check:

USB cable
USB driver installation
Microsoft.NET Framework 1.1 installation.
If ZP Recorder software (optional) is running, it should be
closed.