Checkline ZP - Manual (Page 4)

page 17 page 4
Installing Microsoft .NET Framework
Microsoft .NET Framework 1.1 or later must be installed prior to
running ZP Logger software. If Microsoft.NET Framework 1.0 has
been previously installed it must be removed.
1. Check to see if you already have the .NET Framework installed
by clicking Start on your Windows desktop, selecting Control
Panel, and then double-clicking the Add or Remove Programs
icon. When that window appears, scroll through the list of appli-
cations. Highlight and remove all .NET applications earlier than
version 1.1. If you see Microsoft .NET Framework 1.1 listed, you
do not need to install it again. Proceed to install ZP Logger.
2. Once you have removed ver-
sions earlier than 1.1 or if
no Framework is installed,
insert Driver CD-ROM
included with your Imada
force gauge. Double click
the DOTNET folder and
install the dotnetfx package by double-clicking the icon.
3. Eject Driver CD-ROM and restart the computer.
Install ZP Logger software
1. Insert the Driver CD-ROM and open the
ZPR folder. Double click the ZP Logger
icon.
2. Follow the on screen instructions:
3. Choose “close” when installation is
complete.
4. Eject the Driver CD-ROM.
PREPARATION
To connect the remote sensor to the ZPS display unit, rotate the
round connector to find the matching groove, then push it in
until positive connection is made. To disconnect, first slide the
ribbed cover of the connector back, then pull out the connector
(DO NOT ROTATE THE CONNECTOR WHEN PULLING OUT).
OPERATION
Selecting Units
Press to turn on the gauge. The LCD display briefly shows the
capacity of the gauge and then zero with a measuring unit (facto-
ry setup is lbf). If you want to change to other units:
1. Turn off the gauge.
2. Press again while holding to enter Power-Off program-
ming mode (CF9 flashes with solid nn0).
3. Press to display U-03 with a unit, then press or to
cycle desired units (ozf or lbf, gf or kgf, and N), and press
to select (CF9 flashes with solid End).
4. Press to exit 1st. programming mode.
Once units are selected, the gauge retains them as a default.
ROTATE CONNECTOR TO FIND THE
GROOVE
LM
'S' TYPE
BOX TYPE
PUSH IN UNTIL IT MAKES A
POSITIVE CONNECTION SLIDE BACK RIBBED COVER,
THEN PULL OUT CONNECTOR
RIBBED COVER
REMOTE SENSORS
DPU both tension and compression
Low capacity: Box Type (±0.2% F.S.; ±1 LSD)
High capacity: S Type (±0.2% F.S.; ±1 LSD)
LM compression only (±0.5% F.S.; ±1 LSD)
IMPORTANT: Load applying surface must be flat