Checkline FGV-XY - Manual (Page 18)

– 18 –
8.1 Setting the Memory Mode
1. Turn the POWER off.
2. Press PEAK and hold, then press and release POWER.
The display will show the HI Comparator limit
3. Press PEAK twice to display the current memory mode.
4. Press UNIT to cycle the Memory mode
5. Press MEM to save and exit.
The following items are found in the Comparator/Memory mode settings.
Setting Display Content Default Factory Setting
Comparator HI limit HI Current HI limit 0
Comparator LO limit LO Current LO limit 0
Memory Mode MEM Current Memory Mode Std
– 19 –
PEAK
PEAK
PEAK
MEM
UNIT
UNIT UNIT
PEAKPEAK
PEAKPEAK
PEAKPEAK
MEMORY MEMORY
UNITUNIT
UNITUNIT UNITUNIT
Setting the Memory Mode
8.2 Recording Memory Data
The following procedures explain how to activate memory recording for
each memory mode
Continuous Mode:
1. In the Continuous Measurement Mode, Press MEM to start recording.
The letter M will appear and start blinking. Press M to stop recording.
2. If 1000 points of data are recorded, the display will show FULL and
return to standard measurement mode.