BUCHI NIRWare - Manual (Page 207)

NIRWare 1.5 Software Manual NIRWare Suite

201
Property assigned by user. This property can be removed from samples as long as the
corresponding samples are not used in a calibration.
Deleting individual samples
Individual samples can be deleted under certain circumstances:

not connected to routine measurements to which reports are available

not used for calibration development
Information about this can be found by selecting a single or group of samples in the bottom window in
case the deletion was not possible:
NOTE
Delete only individual samples from a sequence in case you wish not to delete the whole sequence or
imported samples (from data conversion or import without application) under "Samples". Delete complete
measurement sequences under "
Measurements ".
6.3.5. Measurements
Measurements
In the tree view on the left side of the NIRWare Management Console select Sample Management -
Measurements.
The following dialog opens:
Table columns
The table consists of the following columns: