Brookfield Temperature Controller, Model 106 - Manual (Page 10)

Brookfield Engineering Labs., Inc. Page 0 Manual No. M/02-207-C009
V.2 RUN
STBY
The Run/Stby Key
The RUN/STBY key initiates or stops operation of the Programmable Temperature Controller. To
initiate a temperature program or single setpoint operation, press RUN/STBY. The LED labeled
RUN will light up to indicate the present status of the controller. When the Temperature Control-
ler is operating, pressing the RUN/STBY key will place the unit in a standby mode and cease
control of the Thermo Container.
V.3 SET The Set Key
The SET key is pressed when the operator wants to view or edit temperature and time data. In
single setpoint (non-program) mode, the SET key accesses the temperature setpoint. In pro-
grammed mode, the SET key is used to cycle through the time/temperature program and to ac-
cept various options when the user is “building” a temperature/time program.
V.4 PGM The Program Key
The PGM key is pressed when the operator wants to establish, review or use a temperature/time pro-
gram. The LED labeled PROGRAM is illuminated when the Programmable Temperature Controller
is in the program mode.
V.5
p q
The Arrow (direction) Keys
The ARROW keys are used to increment (or decrement) temperature values and to scroll through
sub-program options where required. When used to input temperatures, a single press of either
of these keys will result in a single digit increment in the displayed temperature value. When
large temperature steps are required, the user will find it simpler to press and hold these keys. At
first, this will result in a slow increment (or decrement) of the display temperature. However,
after a couple of seconds, the display will rapidly increment (or decrement) and the user must be
careful not to overshoot (or undershoot) the desired input value.
These keys will not work when the Programmable Temperature Controller is in the run mode.
V.6 HEAT The Heat LED
The HEAT LED is illuminated when the controller is providing power to the Thermo Container.
The LED will flash at a rapid rate when the temperature of the Thermo Container is being main-
tained at a programmed temperature.