Brookfield R/S CPS Rheometer - Manual (Page 42)

Brookfield Engineering Labs., Inc. Page 42 Manual No. M08-218-B0212
VI.7.5 Configuration →RS232 Parameters
This function allows the preselection of interface parameters.
The serial interface operates without handshake.
Data is transferred as ASCII text.
Parameters to Set
Baud rate [Baud] 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200
Parity n(= no parity) e(=even) o(=odd)
Stopbits [Bit] 1 or 2
Databits [Bit] 7 or 8
The standard setting is:
Baud rate = 4800
Parity = n
Stopbit = 1
Databits = 8
If you change these settings, you also have to set the new transfer
parameters of the receiving device!
After starting the RS232 Parameters function, you will be prompted to enter the baud
rate:
RS232: 4800,8,n,1
Change RS232-Par.?
YES NO
Press the
OK key to initiate the input of parameters.
You may enter the following parameters in succession:
• Baud rate [Baud]: 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200
• Databits [Bit]: 7 or 8
• Parity: n (=none) e(=even) o (=odd)
• Stopbits [Bit]: 1 or 2
Select the required parameter from the list of available parameters and accept the selection
by pressing the
OK
key.
Example: Baud rate
Baud rate:
-4800
-9600
-19200