Compaq V6500 - Manual (Page 80)

f . Top cover (see Top cover on page 64 )
g . Audio board (see Audio board on page 74 )
h . USB/power connector board (see USB/power connector board on page 70 )
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
● Memory modules (see Memory module on page 44 )
● RTC battery (see RTC battery on page 46 )
● WLAN module (see WLAN module on page 47 )
● Bluetooth module (see Bluetooth module on page 67 )
● ExpressCard assembly (see ExpressCard assembly on page 68 )
● Fan/heat sink assembly (see Fan/heat sink assembly on page 75 )
● Processor (see Processor on page 78 )
Remove the system board:
1 . Remove the USB/power connector board cable (1) from the clips built into the base enclosure.
2 . Remove the Phillips PM2.5×4.0 screw (2) and the Phillips PM2.0×7.0 screw (3) that secure the
system board to the base enclosure.
3 . Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an
angle.
4 . Disconnect the audio board cable (3) from the system board.
72 Chapter 4 Removal and replacement procedures