Adaptive Technologies PM-AW2-G User Manual

Polestar ™ pm-aw2-g, Aw2 & aw5 ub adapter for pole mount

PoleStar

™

PM-AW2-G

AW2 & AW5 UB Adapter for Pole Mount

Installation Instructions

The PM-AW2-G adapts the JBL AW2 and AW5 Series all weathered loudspeakers to the
PM Mount series. It provides a center single hole mounting while adding extra support to
the AW2 and AW5 series U-bracket. The single mounting hole provides and easy and
flexible way to rotate the speaker horizontally to any desired direction.

Important:
Mounting overhead systems require professional experience. Improperly installed

equipment can result in property damage, personal injury, death and/or liability to
the installing contractor. Do not install if in doubt about the integrity of the mounting
structure.

Caution:
Due to the wide variety of mounting structures, environments, materials and mounting
methods, the installing contractor must exercise good judgment in selecting the proper

mounting area and hardware.

Safety cables is recommended from the speaker to another structurally safe mounting
point

Follow these instructions for the most efficient and safest mounting results.

Do not exceed the working load limit of 100lbs/45 kg.

Do not use Pneumatic tool to tighten bolts

Package Contents:
1 pc

Pole Mount UB Adapter

8 pcs

Hex tap bolt,M10x30mm

16 pcs Flat washer, M10x20mm OD
8 pcs

Hex nylock nut, M10

Step1:
Install selected Pm-Series pole mounting system.
Refer to the installation instructions

Step 2: Attach Adapter
Attach the PM-AW2-G to the selected pole mounting system using the provided bolts,
washer, nuts and friction washers that comes with the Pole Mounts. Make sure that the
friction washer is in between the Adapter and the Pole Mount per installation instruction
(Figure 1)

Snugly tighten the bolts and nylock nut, the adapter should be able to rotate when pushed.

Step 3:
Attached the U-bracket and loudspeaker assembly (AW2 or AW5 Series U-Bracket) to the
adapter by centering the U-bracket to the adapter then match the holes of the adapter to
the slots on the U-bracket. Secure with the provided M10 hex bolts, flat washer and nylock
nuts. Tigthen screws permanently (Figure 2)

Single mounted AW2 loudspeaker

Double mounted AW2 loudspeaker

Triple mounted AW2 loudspeaker