360 Systems MAXX-2400SD - Manual (Page 112)

____________________________________________________________________________________
Page 112 MAXX 2400 Owners Manual
APPENDIX A – SETTING THE AUDIO JUMPERS FOR
ANALOG/DIGITAL
Analog/Digital Audio Selection
Figure 51 indicates jumper positions to select between analog or digital audio. Note that each
output may be individually selected. As described earlier, when analog audio is selected, only
two channels are available, while selection of AES/EBU digital audio provides two stereo pairs,
one on each XLR connector. Both jumpers for each channel (Left & Right, or Main & Aux) must be
set together, either analog or digital. The MAXX 2400 must be power cycled for jumper changes
to take effect.
1. Power off the unit. REMOVE BOTH POWER CORDS
2. Remove the Chassis top by depressing the two blue release button, then sliding back and
up.
3. The Audio board is the left most PCI card viewed from the front of the unit. Remove the
PCI hold down screw. Remove Four connectors on one side of PCB per Figure 49
4. Remove the genlock cable ( Figure 50 ) on the opposite side of the PCB by pulling gently
away from the PCB.
5. Rock the board up and out of the PCI slot.
6. Configure the jumpers according to Figure 51.
7. Replace the board, connectors and the lid.