Panasonic OMNIVISION PVQ-1310 - Manual (Page 22)

Tape Operation (continued)
Direct Access (For Normal and/or Timer recordings)
Go directly to the desired recording,
^ ---------------¡¡Till---------------- Display SELECT
SEARCH MODE screen.
Press SEARCH in
Playback or Stop mode.
• If there are no Timer
Recordings on the Program
Index List, go to step 3.
2
SELECT SEARCH MODE
ZERO SEARCH
INDEX SEARCH
PROGRAM END SEARCH
PROGRAM INDEX SEARCH
SELECT:A ▼ KEY
SET ;► KEY
END :SEARCH KEY
Display INDEX screen.
1) Press AT
to select
“INDEX
SEARCH.”
2) Press ► to
display.
This screen appears only if
there are Timer Recordings.
Select the recording
number.
Pre‘?s
NUMBERED
keys.
To calculate number, see below.
4
INDEX
04
INDEX SEARCH
04
start search.
Press FF or REW.
• When search is
finished, playback
begins.
To calculate the Index Number
Example 1;
If you are watching recording 4 and you want to watch
recording 2, enter 3 in step “3” and press REW.
1 2 3
k
4 5 6 7
Example
f you are
recording
2:
watching
6, enter 4
record! n
in step
g 2 and
“3” and
you
W£
dress F
mt to watch
F.
1 3 4 5 6 7
NOTE: I indicates start points of each recording
22
VHS Index Search System is ...
Each time recording is made, an invisible
index mark is placed on the tape. When
timer recordings are made, program
index and information are also included.
These index marks can be used to
access or scan recordings.
Model PVQ-2510 unît Is shown here.
SELECT/SET
CH UP
CH DOWN
VOL UP
3 numbered
Keys
1
SEARCH
4 f F or REW
Make each entry within 10 seconds, or
the Index Search mode will be canceled.
If these VHS Index Search Systems are
started very close to an index mark, that
index mark may not be counted in the
search.
For assistance, call 1-800-211-PANA(7262)