Caution for ac mains lead, For united kingdom) – Panasonic RX-E300 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Caution for AC mains lead
(For United Kingdom)
(“EB” area code model only)
For your safety, please read the following text care
fully.
This appliance is supplied with a moulded three pin
mains plug for your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure
that the replacement fuse has a rating of 5-ampere and
that it is approved by ASIA or BSI to BS1362.
Check for the ASIA mark or the BSI mark ^ on
the body of the fuse.
If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used
until a replacement cover is obtained.
A replacement fuse cover can be purchased from your
local dealer.
CAUTIOM!
IF THE FITTED MOULDED PLUG IS UNSUIT
ABLE FOR THE SOCKET OUTLET IN YOUR
HOME THEN THE FUSE SHOULD BE RE
MOVED AND THE PLUG CUT OFF AND DIS
POSED OF SAFELY.
THERE !S A DANGER OF SEVERE ELECTRI
CAL SHOCK IF THE CUT OFF PLUG IS IN
SERTED INTO ANY 13-AMPERE SOCKET.
If a new plug is to be fitted please observe the wiring
code as shown below.
If in any doubt please consult a qualified electrician.
IMPORTANT
The wires in this mains lead are coloured in accor
dance with the following code:
Blue:
Neutral
Brown: Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured mark
ings identifying the terminals in your plug, proceed as
follows:
The wire which is coloured BLUE must be connected
to the terminal in the plug which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be con
nected to the terminal in the plug which is marked with
the letter L or coloured RED.
Under no circumstances should either of these wires
be connected to the earth terminal of the three pin
plug, marked with the letter E or the Earth Symbol ^.
Before use
Remove the connector cover as follows.
How to replace the fuse
1. Remove the fuse cover with a screwdriver.
2. Replace the fuse and attach the fuse cover.