Panasonic RX-E300 - Manual (Page 21)

Recording CD
3 2 23 451
Recording tracks from several CDs onto a
single tape
If there is stiil room on the tape after one CD has been recorded, the
unit will be set to the recording standby mode.
1
2
Make a recording from the first
CD.
CD EJECT Press ^ and change the CD.
Flashes.
EASYCDREC Press EASY CD REC.
Recording now starts from the position
on the tape.
r Tt i n-n f
U M t U'U 1
When another CD is not going to be recorded in succession, press □
STOP to release the recording standby mode.
Recording your favorite tracks
After programming your favorite tracks {see steps 1 to 4 on page 16),
perform steps 2 to 5 on page 20.
Your attention is drawn to the fact that recording pre-recorded
tapes or discs on other published or broadcast material may
infringe copyright laws.
Type of tape which can be used for recording:
Normal/TYPE I O
CrO/TYPE II 0
Metain’YPE IV X
Recording using an alternative method
to easy CD recording
This method is used in the following cases:
•When recording CD tracks onto the remainder of a tape containing
recorded material
•When recording from the reverse side
•When recording tracks with a long time in their original sequence
2
STO^
CLEAR
± EJECT
3 ^
^ DOLBY
REV MODE
REC PAUSE
OQD
PLAV/PAUSC
Insert the CD and press □
STOP/CLEAR.
Press ^ EJECT and load the
tape with the side to be re­
corded first facing you.
Play and find the position on the tape
where the recording is to start.
(When recording from the start of side A
or B, have the leader tape wound up
before proceeding.)
Press DOLBY NR to select the
Dolby noise reduction setting.
(See page 19.)
Press REV MODE on the re­
mote control to select the re­
verse mode. (See page 19.)
Press REC PAUSE.
The dS indicator flashes.
Press l>ai] PLAY/PAUSE.
Recording now starts.
To take up the leader tape:
Magnetic part
tape (sound can
be recorded) —
Leader tape
(sound cannot /» -*
be recorded)