Panasonic RX-E300 - Manual (Page 10)

Programming Broadcast Stàtìons
Once broadcast stations have been programmed, they can easily be
tuned in at the touch of a button on the unit or on the remote control.
ForU.K.:
Up to ten LW, WIW and FM stations each can be programmed in the
preset channeis.
For Australia and New Zealand:
Up to ten FM and AM stations each can be programmed in the
preset channels.
1 2*4 3*5
Example: Programming FM 88.10 MHz In preset channel 2;
ForU.K.:
Press BAND to display “FM” .
LW^MW^FM----------------------------------1
c
(The display changes each time the but­
ton is pressed.)
For Australia, New Zealand:
Press BAND to display “FM”.
AM-»-FM-------------------------------------- 1
C
(The display changes each time the but­
ton is pressed.)
ot>fl
Press D<]
»/ooa
to se-
Tlìné SET
lect the station.
FM stations can be selected automati­
cally (see right).
lw( oo
( (
UU. tu
ADJUST Press ADJUST.
Flashes.
---------------- \ i > —
c
( t 1
( ' ■ '
)
HIITUn Q3
10
iKit>/t>i>a
Tti«£ SET
K
Press [KK/« or i>i>/[>oa to
display the preset channel in
which the station is to be pro­
grammed.
Preset channel
C h^t
---------1------- 5—---------------
1 - -
f 1 i
,_______________
ADJUST While is flashing, press
Qw ADJUST.
MEMORt:^
Repeat steps 2 to 5 to program
the other stations.
Seiecting FM stations automatically:
Keep pressing exk )/< w or e »/>W] until the frequency display starts to
change. A station with good reception is automatically selected and
the selection process then stops.
To stop the selection at any time:
Press 0«/« or »/[>{>0 again.
The selection may stop without tuning into any station if there is
interference in the vicinity. In such a case, tap d < i m or w>/i>t>a until
a station’s frequency is picked up.
Programming AM (LW/MW) stations:
1. Press BAND in step 1 to display AM (LW/MW).
2. Perform steps 2 to 6.