Panasonic WV-CP214 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(10) Electronic Light Controt/Automatic Light
Control Selection Switch (ELC/ALC)
This switch is used to select the lens as follows.
ALC;
Choose this position when using an auto iris
lens.
ELC:
Choose this position when using a fixed or
nnanual iris lens.
(11) Detail level Selection Switch (SOFT/SHARP)
The detail/aperture level can be selected by this
switch. Set the switch to the desired position while
observing the picture on the monitor.
Note:
Usually set this switch to SHARP position.
When Quad System is connected to this cam
era, set this switch to SOFT position.
(12) Automatic Tracing White Balance Control
ON/OFF Switch (ATW, ON/OFF (AWC))
The white balance setting can be selected as;
ON:
The white balance is automatically and con
tinuously set by detecting the characteristic/
color temperature of light source through the
lens and controlling the gain of red and blue
signal even if the characteristic/color tempera
ture varies.
OFF:
The white balance is automatically set and
fixed by detecting the characteristic/color
temperature of light source through the lens
and controlling the gain of red and blue sig
nal.
(13) ATW Control (ATW ON, R/B)
This control adjusts the level of red and blue color
balance when ATW ON/OFF Switch (12) is set ON
position. It is preset at the center position which
usually provides accurate color reproduction.
(14) Video level Control (VIDEO LEVEL, UH)
This control adjusts the level of auto iris control
when the selection switch (10) is set to ALC posi
tion, or the level of electronic light control when the
selection switch (10) is set to ELC position.
Note:
Adjust this control while setting the AGC
ON/OFF Switch (9) to OFF position.
(15) DC 12V In Terminal (DC 12V IN)
This terminal accepts 12V DC power source
(10.5V- 16V)
- 6 -