Copying your tapes (dubbing), Playing (source) vcr, Recording (editing) deck – Panasonic PV-D4734S User Manual
Page 35: Press play, then pause press rec, then still/pause, To monitor dubbing on tv, I selecting the input mode, O o o, Connection
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

copying Your Tapes (Dubbing)
Connection
VCR/ Camcorder
iHi-Fii
DVD/VCRDECK
Front of DECK
VIDEO M
2
L-AUOlO IN
2
-R
o o o
(Audio/Video In Terminals
on the front of DECK are
available)
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK.
To monitor the dubbing, also connect TV as shown.
Connect “L” and “R” AUDIO OUT terminals on Playing VCR to “L” and “R”
AUDIO IN terminals on DECK.
In place of Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit’s Audio/Video outputs to DECK.
1
Playing (Source) VCR
Insert a pre-recorded tape.
Recording (Editing) DECK
Insert a blank tape with record tab.
Press INPUT
to set DECK Input mode to
LINE for Video Input.
(See “Selecting the Input Mode” below.)
Press PLAY,
then
PAUSE
Press REC,
then
STILL/PAUSE
immediately to enter PLAY/PAUSE immediately to enter REC/PAUSE
mode.
mode.
______ The operation of steps 4 and 5 must be done on the ________________________
playing and recording VCRs at the same time.
Press PLAY
to start dubbing.
Playing VCR starts playback.
Press STILL/PAUSE
to start dubbing.
DECK starts recording.
Press STOP
to stop dubbing.
Press STOP
to stop dubbing.
To Monitor Dubbing on TV
1
Turn TV on and tune to the Recording
VCR channel (CH 3 or CH 4).
2
If Auto VCR/TV (see p. 32) is set to
“OFF,” press VCR/TV on the remote
for VCR mode.
• Dubbing tapes protected with Copy
Guard will result in poor quality
recordings.
I
Selecting the Input Mode
Method 1:
Press INPUT
repeatedly.
Channel Number^ LINE1 <-* LINE2
Method 2:
Press CH
A/T.
Display will change as below.
-------►!
(CABLE) (TV) ¡Press A
------ ------------
V.*.WlNE2«-LINE1<-^125 or 69-<-^
“LI" or "L2" lights up on Multi Function Display
(about 4 seconds) when LINEI or LINE2 is selected.
LINEI : For rear audio/video connection.
LINE2: For front audio/video connection.
Caution: «Unauthorized exchanging and/or copying of copyrighted recordings may be
copyright infringement.
• Piease note that some tapes cannot be dubbed on DECK.
Also, it is not possible to dub DVD/ CD to VHS tapes using DECK.
• When
0
appears on the screen while a button is being operated, it means
that the corresponding operation is prohibited by DECK or the disc.
35