Precaution on battery use, Installation – Panasonic CT-20G21 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installation

Receiver Location

This unit IS intended to be used wilh an optional stand or enlertainment center Consult your dealer Гог available options

Locate Гог сотГогГаЫе viewing Avoid placing where sunlight or other bright light (including reflections) will Fall on the

screen

Use of some types оГ fluorescent lighting may reduce remote control transmitter range
Adequate ventilation is essential to prevent internal component failure Keep away from areas of excessive heat or
moisture

To insure optimum

color

purity do not position magnetic equipment (motors, fans, other speakers, etc ) nearby

Optional External Equipment Connections

The Video/Audio connections between components can be made with shielded video and audio cables For best perfor

mance, video cables should utilize 75 ohm coaxial shielded wire Cables are available from your dealer or electronic
supply house

Before you purchase any cables, be sure you know what type of output and input connectors your various components
require Also determine the length of cable you'll need

AC Power Supply Cord

CAUTION. TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE

SLOT OF AC OUTLET AND FULLY INSERT DO NOT USE THIS (POLARIZED) PLUG

WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY

INSERTED TO PREVENT BLADE EXPOSURE

Remote Control Battery Installation

Battenes Use two "AA" batteries
1

Turn the Transmitter face down To remove top cover, press down on

marking and slide cover off in the direction indicated

Install the batteries as shown in the battery compartment (Polarity (+) or
(-) must be correct)

Replace the cover and slide in reverse until the lock snaps

For heavy Remote Control use, replace old batteries with Alkaline
batteries for longer life

Precaution on Battery Use

Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter

Observe the Following Precautions:

Batteries must be replaced as a pair

Do not combine a used battery with a new one

Do not mix battery types (Example “Zinc Carbon" with “Alkaline”)

Do not attempt to charge, short-circuit, disassemble, heat or burn used

batteries

Battery replacement is necessary when Remote Control reacts

sporadically or stops operating the Receiver

This manual is related to the following products:

CT-20G31