Panasonic OMNIVISION VHS PV-V4521 - Manual (Page 8)

Connections and Initial Setup
How to Connect
Initial Setup for ANT./Cable - VCR - TV
(J) Connect the Cable from
Antenna/Cable to the IN
FROM ANT. terminal on VCR.
0 Connect the OUT TO TV
terminal on the rear of VCR
to the ANT. IN terminal on
TV using the RF Cable
(included accessory).
Initial Setup for DSS/Cable Box-VCR-TV
® Connect the OUT Jack on
your cable box to the IN
FROM ANT. terminal on the
VCR with an RF cable.
© Connect the OUT TO TV
terminal on the rear of VCR
to the ANT. IN terminal on
TV using the RF Cable
(included accessory).
VCH IN FROM ANT.
VHF/UHF
How to do Initial Setup
1
2
Press VCR* for VCR mode. Turn
the TV on and set it to channel 3.
Turn VCR on.
When VCR is turned on the first
time, SELECT LANGUAGE screen
appears.
3
Press CHA to select English,
or
Press CHV to select Spanish,
or
Press VCR/TV key to select French.
When one of above keys is pressed,
CHANNEUCLOCK AUTO SET screen
appears.
SELECT LANGUAGE
PRESS CH A t ENGLISH
OPRIMIR CH ▼ ; ESPAÑOL
APP. VCR/TV : FRANÇAIS
TO CHANGE VCR' S OUTPUT
CH. PRESS ACTION KEY.
VCfl fCLOCK fCHANNEL
«EL/CL0CK .iiUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX. TUNE IT TO YOUR
LOCAL PBS CH THEN, . .
PLEASE PRESS CH UP KEY
If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4.
When you want to change the output
channel of VCR, please refer to VCR’s
Output Channel on page 11.
If wrong language is set, do “Reset All
VCR Memory Functions” steps on
page 9.
If you use a cable box, turn it on and set it to
the Public Broadcasting Station (PBS)
channel in your time zone. If you use DSS
receiver, it must be turned off.
r WARNING-----------------------------------------------
When using “Nut type" RF coaxial cables,
tighten with fingers only. Overtightening
may damage terminals.
8 For assistance, please call : 1-80[>-211-PANA(7262) or send e-mail to : [email protected]