Panasonic TX-47P600H - Manual (Page 31)

Aspect Controls
Mode Picture Explanation
AUTO
o
16:9 Signal 4:3 Signal
The AUTO position can be set to 4:3 or to
JUST. When a wide screen signal is
detected at the Video terminal the TV will
select the 16:9 aspect ratio.
Red 4:3 Select 4:3 mode
Green JUST Select JUST mode
4:3
This option will display a standard 4:3
picture without any stretching or
compression. There will be vertical gray
lines down either side of the picture.
This option allows you to magnify or reduce
nart nf the niriiire
ZOOM
part of the picture.
Red V SIZE -
Green V SIZE +
Yellow V POS -
Blue V POS +
Reduce the picture
Magnify the picture
Move picture Down
Move picture Up
S-ZOOM
S-Zoom displays part of the picture at a
greater magnification than the Zoom mode
does. The coloured buttons let you change
the position of the magnified area.
Red H POS - Move picture Left
Green H POS + Move picture Right
Yellow V POS - Move picture Down
Blue V POS + Move picture Up
1 6 : 9
The 16:9 option will display the picture at
its maximum size. Signals in the 4:3 format
will be stretched to fit the picture.
16:9 Signal 4:3 Signal
1 4 : 9
The 14:9 option will display a 4:3 signal in
simulated wide screen. The picture is
slightly stretched. It is also slightly cropped
top and bottom.
The colour buttons let you change the
position of the stretched area.
Yellow V POS - Move picture Down
Blue V POS + Move picture Up
JUST
JUST gives you a best fit option when
showing 4:3 on wide screen. The centre of
the picture is not affected but there is some
stretching at the edges.
Note:
ASPECT operations cannot be made during progressive (Y, P b , P r ) or 1080i signal input.