Panasonic TX-47P600H - Manual (Page 24)

Tuning Channels
Sound System Selection (Different region use differing systems)
This function is used only in the TV mode when the sound is not clear or no sound is produced on a Programme
Number, and is not applicable in AV mode.
1
Press to select the “SOUND SYS”.
Press until the optimum sound is obtained.
I
The sound system will change as shown.
4.5MHz <-> 5.5MHz
c
6.5MHz <-> 6.0MHz
a
SYS SELECT AUSTRALIA
AUTO TUNE
MANUAL TUNE
5.5 MHz
Note:
Sound System Condition.
These are different sound broadcast transmission systems applicable to differing countries.
2 STR
Press to store the Sound System.
TV/AV
Press to exit from the “SOUND SYS”.
This returns the set to the normal viewing condition.
Colour System Selection (Different region use differing systems)
If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, this function is used.
Press to select the “COLOUR SYS”.
Press to produce the optimum image.
i
The colour system will change as shown.
AUTO PAL<^ SECAM ■ I—^AUTO PAL<-^ SECAM —i
NTSC3.58 <------- ^ NTSC4.43-^
ÌliJiiM«LMdM№
SYS SELECT
AUTO TUNE
MANUAL TUNE
SOUND SYS
AUSTRALIA
cmnuRfivs I
5.5 MHz
AUTO
Colour System Condition.
Note:
PAL, SECAM and NTSC 3.58 are different colour signal broadcast transmission systems applicable to differing countries.
NTSC 4.43 is a trick playback mode used in special VCR to playback NTSC recorded video tapes through PAL
television equipment.
STR
Press to store the Colour System.
TV/AV
Press to exit from the “COLOUR SYS”.
This returns the set to the normal viewing condition.
Od