Panasonic SC-AK14 - Manual (Page 28)

Using the timer
Using the play/record timer
To check settings
While the unit is on and the “©PLAY” (or “®REC”) indicator is on,
press [CLOCK/TIMER] so ‘^PLAY" (or “^REC") appears on the
display.
Two seconds after “©PLAY" (or ‘^REC”) appear, the settings are
displayed in the following order:
• For play timer • For record timer
® Play start time ® Recording start time
(2) Play finish time @ Recording finish time
@ Play source @ Recording source
(5) Playback volume
You can check the settings even when the system is OFF by pressing
[CLOCK/TIMER).
To enjoy the desired source after the timer setting is completed
The volume level (for play timer) and music source are stored in the
timer memory and the timer wilt start in these preset conditions.
However, the Disc numbers and reverse mode do not get stored in
the timer memory.
1. After step B, start playing the desired source.
2. Reset the Disc numbers and reverse mode if you have changed
any of them, confirm that a Disc or cassette is inserted, then press
[0/1, POWER] to put the unit on standby.
Turning the timer ON/OFF
One of the timers is on when the [©PLAY/©REC] indicator is lit.
When the unit is on (or off and in NORMAL mode) you can confirm
which is on by checking which indicator is on the display.
When the unit is off and in ECO mode, press [CLOCK/TIMER]. The
display will then show which timer is on and the settings that have
been made (see above).
To change the timer, press [©PLAY/©RECj.
Each time the button is pressed the setting changes as follows.
©PLAY — ©REC
I— (OFF)
• If you switch the system to the standby mode while the play/record
timer is functioning, the OFF time setting will not be activated.
• If AUX is selected as the source, when the timer comes ON, the
system will turn ON and will engage “AUX" as the source. If you
want to playback or record from a connected component, set the
component’s timer to the same time. (See the instoiction manual
that came with the component.)
RQT5539